Baby Creation

TEST PROCEDURE

1.To begin testing, open the sealed pouch by tearing along the notch. Remove the test kit from the pouch.

2. Hold the round end with the cap with one hand. Use the other hand to pull out the test device and expose the absorbent sampler.

3. Pointing the absorbent tip downward, place the absorbent tip in the urine stream for at least 10 seconds to become thoroughly wet. Alternately, you can collect your urine into a clean, dry container, and dip half of the absorbent pad into the urine for at least 10 seconds.

4. Re-cap the device and wait for colored bands to appear. Depending on the concentration of hCG, positive results may be observed in as little as 40 seconds. However, to confirm negative results, the complete reaction time of 5 minutes is required. Do not read results after more than 10 minutes.

INTERPRETATION OF RESULTS

 
Negative: Only one color band appears on the control region. No apparent band on the test region. This indicates that no pregnancy has been detected.
 
Positive: Distinct color bands appear on the control and test regions. Presence of both test line and control line indicate that you are pregnant. The color intensity of the test bands may vary since differenct stages of pregnancy have different concentrations of hCG hormone.
 
Invalid: No visible band at all. Repeat with a new test kit.
 

STORAGE AND STABILITY

The test kits can be stored at room temperature (18 to 30°C) in the sealed pouch/baggy to the date of expiration. The test kits should be kept away from direct sunlight, moisture and heat.